|
Parts needed to make your own pressure test unit:
- Car gas line fuel-vacuum pressure tester gauge
- Fuel line 5/16 brass tee and clamps
- 5/16 rubber fuel line about 2 feet
- Bike air pump for pressure about 8 lbs for testing older seals and 16 lbs for new seal installed if you used
loctite installing them if not than 8 lbs as well
- Portable small bilge pump fill give you 5 to 8 inches of vacuum
- 3/8 oil fill fitting Note can be taken off unit that used for filling gearcase with oil, sold at most marinas
|
